Look up DJ Todds DIY it was helpful when I did mine. Cranck sensor bolt is the hardest to get at mark your drive shaft flages so it goes back the same as you took it off. The transmission is actualy pretty light about 80 lbs or so. I rented a puller from autozone...I had to file the back side of the fingers slightly to get it to go in. FYI the fluwheel bolt are a #40 star bit I think, star bit for sure that size may be off. Have a good torque wrench available take your time and have fun. It not that bad just takes some time to take off all the crap to get at what you need.
__________________
Stillen Gen III/ NST/ Fast Intentions Non-Res HFC & 12" Resonated CF TDX/ Setreb series 9 OC/ SPL upper control arms/ Whiteline front & rear swaybars/ Uprev tuned by Seb@specialtyZ/ 319HP 262TQ/ Z1 PS Cooler/ Z1 SS Premium break lines/ CJM Road Race pump/Carbotech F:XP10 R:XP8 Nismo OC DIY
|