Slight change on the IC piping...of course, to make things better/easier...
The pipe that goes under the transmission and couples to the turbo will be made from two pieces and coupled with a silicone coupler (vs single pipe). The other change is that the section going under the transmission, and in to the compressor outlet will be 2.25” vs 2.5”. This is the same size as the compressor outlet inside diameter, so it is not a reduction.
This will allow for better clearance, and give the installer flexibility in this section.
Here is the two pieces side by side:
On the left you can see how the new revised pipe slides in to the upper pipe. This is where the flexibility will happen, making the install even easier. If, for some reason, somehow this pipe is damaged on the road, over a bump…whatever, I will send a replacement at no charge, and cover the shipping.