View Single Post
Old 07-18-2014, 02:14 PM   #42 (permalink)
Read T
A True Z Fanatic
 
Read T's Avatar
 
Join Date: May 2012
Location: Raleigh, NC
Posts: 1,046
Drives: 11 Nissan 370z BC 6M
Rep Power: 18
Read T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond reputeRead T has a reputation beyond repute
Default

Quote:
Originally Posted by wstar View Post
Well my 18x10+34 (Forgestar) fit fine (if very slightly wide at stock camber) in the front, and use a 10mm spacer in the rear (but that's just cosmetics, you could go anywhere from 0 -> 20 on the rear spacer there and be fine). So I would think you could go 18x10+38 with a ~15mm spacer in the rear and be fine. They're just 4mm further to the inside than mine.

One of the bonuses of the cheap Forgstars is that they're made-to-order and you can spec whatever offset you like.
I'm running the same setup (forgestar 18z10 +34). This is one of the cheaper square setups and not a bad wheel. No spacers needed to run them all around. As with any aftermarket wheel on this car though you will need extended studs (or bolt on spacers with longer studs) to get adequate thread engagement with aftermarket wheels. see below.

http://www.the370z.com/wheels-tires/...ud-length.html
__________________
2011 Nissan 370z Black Cherry Sport Pkg - Daily Driver, , 1960 Morgan +4 fun car, 1986 BMW 325ES, 1998 M3 and 1996 Spec Miata - Race Cars
SUPPORT TEAM WINSOME RACING - WRL, CHUMP, LEMONS
Read T is offline   Reply With Quote