View Single Post
Old 06-24-2014, 01:01 AM   #98 (permalink)
Pro4Jackster
Base Member
 
Pro4Jackster's Avatar
 
Join Date: Oct 2011
Location: NW Houston
Posts: 130
Drives: '08 350Z
Rep Power: 14
Pro4Jackster is on a distinguished road
Default

Quote:
Originally Posted by Z&I View Post
Thought long and hard on this ... and tried my best to do as much research as possible.
With the lower compression it will allow me more boost and more hp at the top.
With the built motor I can go up to 15~16 psi with the 9:1 CR.

The down side is losing some at the bottom...but then again, that might allow me to leave at a higher rpm.
Without having done this though, it is a guessing game.

Thought of the 10:1 CP's as well, but that extra potential 50+hp with the 9:1's was just too tempting.

My Stillen SC'r has been upgraded to SI trim which ups the max boost to 22 psi and 1050cfm.
Vortech has a series of pulleys that will allow me to find the right one.
Hope the V3 SI will be up to the task.
If not then I'll have to go for the V7.

I'm still open for suggestions and input ... the pistons aren't in the motor just yet.
Any and all info welcome here...

Thanks,
The first bit of advice from me is:

Do not confuse the Vortech head units limitations with the Stillen kits limitations. They are two very different things. The Stillen kit is limited by its Pre-S/C intake size/configuration, MAF location and IAT sensor location, charge pipe design, and bracket flex/belt slip.

The Stillen kit is very good at what it does off-the-shelf. But it is not very good for upgrading. You have already maxed the kit out, or you are very close. If you want to keep it and enjoy it, do not chase big power. Build your motor to maximize the air your kit is currently moving. Lowering your CR is not a good way to do that (talk to a few "Stillen S/C" experienced shops). Keep the kit you have already bought and enjoy, keep a CR that is close to stock, upgrade the rods, and get an experienced tuner.

I am in no way telling you what to do, but I've been down this road. And I've seen a few others too. Lowering the CR (on this kit) is just losing power and gaining nothing.

I was getting belt-slip at around 15-16 psi over spinning the blower at 56K rpms with the SI impeller. Look at the amount of belt wrap this kit is designed with on the serp pulley and compare it to other superchargers pushing big psi. Look at the size of the intake going thru the core support compared to other supercharger designs. Look at the MAF/IAT placement compared to other designs.

You have probably already made all of the power you will ever make out of the Stillen kit. The bad part is, now you are going to have a built motor that is capable of much much more. It sounds all too familiar.

I don't want to be the pushy internet guy, so this is the last time I'll say this unless asked. Apologize for getting off-topic.
__________________
Jtranbuilt '08 Z [Jtran PT7075 Single - Fujitsubo - Transgo - Wilwood - TE37SL - BC Racing]

Last edited by Pro4Jackster; 06-24-2014 at 01:07 AM.
Pro4Jackster is offline   Reply With Quote