Well I didnt have a camera with me when I was putting it on but I will do my best to explain the process. I did the install on the floor in my garage. Not a hard job at all, BUT there was a few surprises.
1. Unbolt stock exaust.
2. Bolt on new exaust starting from the front of the car. Kit has all hardware
and gaskets.
3. Everything is pretty cut and dry so far but now at the rear section is where it
it gets a little tricky.. You need to remove the heat shield that was above the stock muffler section in the back.. Next you need to unbold the box with 3 hoses going into it that is in the far right side of the back bumper. looks like box in pic 1
Greddy sent you a new metal peice to put up in the place of the heat shield, using the 4 bolts, bolt it into place then slide the black box into the slider and bolt it down with the small bolt included in the kit. One of the hoses needs to be extended to fit in the new place. Take off that hose and put in the extender with the new hose in the kit and connect it to the box and screw down the hose clamp. now with that out of the way you can finish bolting up the muffler section.
THATS IT!
Sound clip
http://www.youtube.com/watch?v=cKlcmYp672M