View Single Post
Old 05-21-2014, 08:19 AM   #242 (permalink)
onzedge
A True Z Fanatic
 
onzedge's Avatar
 
Join Date: Apr 2010
Location: Battle Lake MN
Age: 64
Posts: 183,964
Drives: 370Z 240Z
Rep Power: 2684736
onzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond reputeonzedge has a reputation beyond repute
Default

Quote:
Originally Posted by Ryan @ RJM View Post
JARblue, you can independently move the height of the lower arm section up/down up to 3/4" by loosening the 3 bolt connection between the upper/lower arms allowing the arm to be "clocked" to a new angle and then tighten it back up again. Although the adjustment you mentioned above with the 2 bearing pre-load bolts is specifically just for aligning the clutch rod for a straight push of the linkage and not intended for height adjustment beyond leveling the rod.
Hope that helps a bit but I suspect what you're trying to do is raise the entire assembly more on the firewall which can't be done.
__________________
Koni|Swift|Michelin|Motordyne|Berk|RJM Performance|Gates|SPL|Motul|Technafit|Ate Super Blue|Hawk
Tommy Kaira|Momo|Optima|Hella|Hotchkis|Red Line|ZSpeed|Stillen|B&M|H&R
onzedge is offline   Reply With Quote