Nissan 370Z Forum - View Single Post - Evo-r Front lip install?

Cmike2780 · 05-12-2014, 01:18 PM

I have the 3-piece kit and it's relatively straightforward to install. The tricky part is getting it lined up properly. You can remove the entire bumper relatively easily with a socket set and install the kit that way. The kit comes with some self tapping screws and double sided tape. Just make sure everything is clean and lined up before removing the tape backing. The only holes you'll need to drill, you won't really see should you decide to remove the lip kit. There are a few on the underside and a few holding up the side pieces that screw to the wheel well lining sides. You'll see where to put them in when you get the kit. The holes should be predrilled on the kit.

05-12-2014, 01:18 PM	#15 (permalink)
Cmike2780 A True Z Fanatic Join Date: Jun 2010 Location: Long Island Posts: 5,059 Drives: slowwww Rep Power: 29	I have the 3-piece kit and it's relatively straightforward to install. The tricky part is getting it lined up properly. You can remove the entire bumper relatively easily with a socket set and install the kit that way. The kit comes with some self tapping screws and double sided tape. Just make sure everything is clean and lined up before removing the tape backing. The only holes you'll need to drill, you won't really see should you decide to remove the lip kit. There are a few on the underside and a few holding up the side pieces that screw to the wheel well lining sides. You'll see where to put them in when you get the kit. The holes should be predrilled on the kit. __________________ [09][MB][6-Spd MT][Touring][Stillen Gen III][K&N][Borla CBE][Evo-R] [ArchitTEK Photography]