View Single Post
Old 05-10-2014, 01:02 PM   #9366 (permalink)
BA9092
Base Member
 
BA9092's Avatar
 
Join Date: Feb 2014
Location: Dallas, TX
Posts: 92
Drives: '13 370Z PW 6M
Rep Power: 11
BA9092 is on a distinguished road
Default

Quote:
Originally Posted by big daddy View Post


I left my out in the hot Texas sun for a couple hours than used fishing line. Cleaned it all up with Goo gone. It took my son and I around an hour to remove, clean and install the new badges.

I did end up with a blister on my finger.
Yup. I'm with JARblue and big daddy.

The emblem removal was probably one of the most painstaking mods. More time consuming than my Ark Grip with just two jack stands in my garage, but once I started, I knew there was no looking back. I took my time with a few breaks and a lot of patience.

The emblems themselves came off rather easy after a few hours in the Texas sun. The grey leftover adhesive took at least an hour more for EACH badge, front and rear. I used the max strength goo-gone carefully to only remove the glue while being careful with the paint that would still be exposed (on top and bottom of the original NISSAN logo) with the new emblem. I dabbed a soaked paper towel with the goo-gone onto the grey leftover adhesive and slowly used both my fingertips and a small, sharp, plastic trim removal tool to work it off.

Lots of paper towels, three blisters on the tips of my fingers, a drenched tshirt from lots of elbow grease and working under the Texas sun, I'm finally happy with the results.
Attached Images
File Type: jpg P1000923a.jpg (255.7 KB, 11 views)
File Type: jpg P1000927a.jpg (251.6 KB, 7 views)
__________________
Ark | H&R | iSimple | Moweraxle | OnEighty | Osram | RJM I Sylvania I TWM | Wincos | Z1 | ZSpeed
BA9092 is offline