Nissan 370Z Forum - View Single Post - Aftermarket Bluetooth Mic in Factory Bluetooth Mic Location

Plasmite · 05-05-2014, 09:29 PM

Ok, so I ran into a problem with the mic I have. It was too long to sit properly in the stock housing, so modifications were needed...

By shaving away the corner, but keeping the attachment point of where the light harness clips to, I was able to make it fit just right

I drilled a pilot hole very carefully with a 1/4 inch bit, then used a very sharp exacto knife to shave the corner out.

05-05-2014, 09:29 PM	#19 (permalink)
Plasmite Enthusiast Member Join Date: Aug 2012 Location: Canada Posts: 259 Drives: '12 M6 Panty Peeler Rep Power: 13	Ok, so I ran into a problem with the mic I have. It was too long to sit properly in the stock housing, so modifications were needed... By shaving away the corner, but keeping the attachment point of where the light harness clips to, I was able to make it fit just right I drilled a pilot hole very carefully with a 1/4 inch bit, then used a very sharp exacto knife to shave the corner out. __________________ WISHLIST