Quote:
Originally Posted by Limeybastard
Great sticky, so just to confirm if I may. I can purchase a hocky puck and cut a slit in the middle, place this on the side front jack point raise car slightly then use another jack to raise the front via the cross member?
|
I bought 4 hockey pucks (this is Minnesota - they even sell hockey pucks in the grocery store). I cut a slot in them slightly off center using a radial arm saw deep enough so that it slips over the notched flange but bottoms out on the rail. I bought four neodymium magnets off Amazon (
http://www.amazon.com/gp/product/B00...?ie=UTF8&psc=1 ) drilled four 1/2 inch holes, and glued them in there so that the pucks would stay put. Works great for me (got the magnet idea from this site somewhere). I did this not only so that I could jack it at home, but so that the thing would go on a typical 4-point lift without damage.