View Single Post
Old 04-18-2014, 10:21 AM   #2 (permalink)
2011 Nismo#91
A True Z Fanatic
 
2011 Nismo#91's Avatar
 
Join Date: Mar 2011
Location: NJ
Posts: 2,401
Drives: slowly
Rep Power: 40569
2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute2011 Nismo#91 has a reputation beyond repute
Default

Long term storage or classic car winter storage
DATE STORED:

CLEAN CAR: No matter where you store the car for the winter, before you put it away it should be cleaned, waxed, and most definitely thoroughly dry. Any form of moisture is an automobile's worst enemy. Even fiberglass cars hate moisture. Just as it will rust metal, moisture can come through fiberglass to bubble the paint, ruin the fabric, carpet and leather. So before putting it away, dry the car and allow ample time for sensitive areas to air dry naturally.

TREAT SEALS: After cleaning, treat all rubber seals around windows, doors and tops with silicone or a similar agent to prevent cracking and aging.

LUBRICATE: Lubricate all hinges on doors, hoods, etc.

FILL GAS TANK: Before storing the car, fill up the tank completely with fuel. If you leave only a little in, rust can form on the exposed surfaces inside the tank.

FUEL ADDITIVE: You can also prevent fuel from breaking down causing damage and varnishing by adding some fuel stabilizer to the full tank and letting it run a little while to circulate in the gas.

CHANGE OIL: After running the car, drain the oil and refill it with fresh oil. Despite having gotten rid of moisture, your oil still has other contaminants in it. Better that those contaminants live at the recycling center than in your main bearings. (filter change not required for storage)

CIRCULATE OIL: With the new oil in, run the car briefly to let the new lubricant circulate.

WARM ENGINE: Before storing the car, drive it 20 -25 miles-no less. This should take a sufficient amount of time for any condensation to be worked off the crankcase surfaces and the oil.

INJECT OIL: This can be done for rare cars and for long term storage needs. If you really want to go to great lengths and are truly obsessed, take a lesson from motorcyclists: Remove the spark plugs and inject a little oil into the cylinders. Reinstall the spark plugs (or an old set of used plugs for storage) without torquing them completely, and crank the motor briefly with the plugs in and the positive lead to the distributor or the coil wire removed. (Don't
let the engine fire.) This will coat the combustion chamber and cylinder walls with a protective layer of oil. Don't restart the car until spring. You will need to change the spark plugs back to your good ones or buy new ones in the
spring because of the oil that fouled them with the protective layer.

BRAKE FLUID: Change the brake fluid. Even if the car doesn't need it desperately, you'll be preventing future problems by changing the fluid. Moisture in the brake lines will cause damage no matter what, even when the car is in use. Many people ignore this bit of maintenance, anyway, so now is time for them to redeem themselves. At this point, also consider switching to silicone brake fluid if you drive you car hard. Racing teams use it. Why not you?

DRAIN RADIATOR: Drain, flush and refill the radiator with new coolant. The same reasoning behind changing brake fluid applies here. Now is a good time to remove your radiator to be hot-tanked over the winter if needed.

BAT T E R Y: Disconnect battery cables and remove the battery for storage inside, but not on a cement floor. You will find a dead battery in the spring if you store it on cement. Very low temperatures also destroy batteries. If you take the car out of storage. Use a battery tender not a trickle charger to maintain the battery.

REMOVE BLADES: Remove wiper blades, especially if storing the car outside. Temperature changes will not do them any good, and they can fuse to plastic or glass over time.

PLUG EXHAUST TIPS: Plug the exhaust tips with material that mice and other rodents won't chew through.

JACK STANDS OR FLAT STOPPERS: Storing the car on jack stands or blocks. Pros: You can remove the old bias-ply tires that may flat spot. You can also remove the wheels and tires and bag or cover them to prevent dry rotting and adverse environmental effects.


BLOCK WHEELS: If you leave it on the ground don't set the emergency brake. Block the wheels in front and back to prevent rolling. Pads and shoes can stick to discs and drums.

PLASTIC ON FLOOR: When storing inside or outside, lay a large sheet of heavy-duty plastic or a tarp (greater than the car's length and width) to prevent moisture rising from the ground or cement and collecting under the car. Outside, this will also prevent grass from growing up and touching the car's underside.

CAR COVER: There are many sources of car covers. Use one! If you do store your car outside, use only an external cover that breathes. Moisture must escape from the cars surface. Ideally a synthetic fabric that sheds water,
yet breathes, shielding from dirt and sun and will not mold or mildew.

STORAGE LOCATION: If you leave your car outside, pick a spot that will be shaded or as dark as possible. Sun can damage paint through a thin cover.

MOISTURE-ABSORBING PACK: If the car is being stored indoors, put a moisture-absorbing pack in the interior (and trunk, for solid-axle cars). DRYPAC is a vendor that makes these packs, which do not smell, swell or
have any adverse effects on the vehicle. However the windows and vents must be closed for them to work.

TRAY OF MOTHBALLS: Put a tray of moth balls inside the car to remove any odors. This will also help to drive away any carpet loving rodents.

SPRING LUBRICATION: When you start up the motor in the spring, first disconnect the spark plug leads (or the positive distributor lead, or the coil) and crank the motor over a few times to get oil up into the bearings, rings and valve train. (You don't want the engine to fire.) Don't remove the plugs themselves, however, as this can damage the starter motor, letting it spin vary fast without the engine's compression limiting it's speed. The motor has sat for a long time, and the oil has dripped completely down into the pan/sump. Starting it and letting it run, even for one to three seconds without thorough lubrication, will cause more wear than 100 trips to the redline!

http://www.rochestercorvetteclub.org...-checklist.pdf
Long-term and Winter Storage Tips for vehicles. - Car Forums and Automotive Chat

Last edited by 2011 Nismo#91; 04-18-2014 at 10:25 AM.
2011 Nismo#91 is offline   Reply With Quote