I'd PM you but I want others to see this too.
This is a lock out kit for $72!!
SPL Eccentric Lockout Kit . But what it really is, is $2 each 10.9 bolts 100mm x 0.46" which can be picked up at advanced auto parts for $8 total. I'd get washers for each side and nuts too obviously. The plates can be made of anything really, they are not load bearing. You just need to cut them 1.33" in width so they fit in between the notches in the subframe.
The trick is to drill your 0.46" hole based on what you want your camber and toe to be. If you drill the hole center and are not in spec you need a plate that has the hole more offset. The beauty is if you make a 1.33x1.33 plate with a offset hole you can turn the plate 4 different directions giving you 4 different toe and camber specs. Takes a little longer for the alignment guy but its not bad to losen the nut, and turn the plate 90 degrees. I used 1/4 thick T6061 plate a foot long by 2" I got for the weight of T6061 at a scrape yard for $0.75c. You can make 100 plates with different off centers before you go blow $72 from SPL.