View Single Post
Old 04-01-2014, 06:28 PM   #16 (permalink)
VDC_OFF
A True Z Fanatic
 
VDC_OFF's Avatar
 
Join Date: Aug 2011
Location: Houston (Pearland)
Age: 44
Posts: 1,205
Drives: 2011 370Z M6
Rep Power: 17
VDC_OFF is a splendid one to beholdVDC_OFF is a splendid one to beholdVDC_OFF is a splendid one to beholdVDC_OFF is a splendid one to beholdVDC_OFF is a splendid one to beholdVDC_OFF is a splendid one to beholdVDC_OFF is a splendid one to behold
Default

what I do is after I drill the hole in the shroud and feed the wire through. I then fille the shroud with silicone sealant. Then I push the halo in place and lightly clean the edges. Dont push the halo all the way to the bottom, you want a slight gap so the glue is still exposed. Then you snap the shaved diffuser over the halo until it touches the glue and the inside of the shroud. The glue under the halo will keep the diffuser from falling off. Clean up and continue your wiring. If you really want to be sure its glued put a small dab on your finger and run it along the inside edges of the diffuser. Its clear so you cant see it.

Last edited by VDC_OFF; 04-01-2014 at 06:30 PM.
VDC_OFF is offline   Reply With Quote