Nissan 370Z Forum - View Single Post - Problems with swift lowering spring install

synolimit · 03-24-2014, 04:33 AM

First, type with spell check/proofreading.

Second, swift doesn't make junk " lowering springs". They make performace springs. Junk springs don't need compressed because they provide zero pre-load. You'll need a good 559 lbs to compress these since 1. They're linear springs. And 2. Proved proper pre-load.

Third, ever think about taking the endlink off the sway bar? Kinda hard to put it back cockeyed.

Forth, if you don't know these are a huge pain to compress for install...why would you be putting the endlink back into the hole? You're not at that point yet.

03-24-2014, 04:33 AM	#3 (permalink)
synolimit A True Z Fanatic Join Date: May 2013 Location: Columbus, OH Posts: 5,051 Drives: 2013 Silver 370z Rep Power: 3389	First, type with spell check/proofreading. Second, swift doesn't make junk " lowering springs". They make performace springs. Junk springs don't need compressed because they provide zero pre-load. You'll need a good 559 lbs to compress these since 1. They're linear springs. And 2. Proved proper pre-load. Third, ever think about taking the endlink off the sway bar? Kinda hard to put it back cockeyed. Forth, if you don't know these are a huge pain to compress for install...why would you be putting the endlink back into the hole? You're not at that point yet. __________________ 13 370z- Last edited by synolimit; 03-24-2014 at 04:35 AM.