Quote:
Originally Posted by cosmogirl
Actually it will but the small bit I have on my dremel would take forever to do. I will look around for something a bit bigger because if I do keep the kit I want to open up so it can flow as much as possible... Rusty please feel free to chime in here...
|
Quote:
Originally Posted by Chuck33079
Problem found. You need a cutting tool with more nuts. Hell, Harbor Freight will have a $20 air die grinder that'll work well enough to do the job. The Dremel is for final finishing, not hogging out that kind of metal. You're also using plenty of cutting oil, right?
|
Yea, you need an air powered 1/4" die grinder with a couple of large football shaped burr bits for roughing. Then a couple of smaller diameter burr bits for finishing. Ball shaped. If you want to go deep into the manifold. Then you need burr bits with a 6" shaft on them. You'll burn up the Dremel on the first port you try to do. I get my die grinders from Sears. I burn them up, and they give me a new one.
Local Sears store has them on stock to boot.