View Single Post
Old 10-31-2009, 04:44 PM   #1 (permalink)
Equinox
Track Member
 
Equinox's Avatar
 
Join Date: Jul 2009
Location: Beaumont, TX
Posts: 685
Drives: 06 Porsche Carrera S
Rep Power: 18
Equinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant futureEquinox has a brilliant future
Default DIY: GT-SPEC 4-Point Ladder Bar

Okay guys, time to install the 4-point ladder bar on the 370z!

What you will need.

(1) 17mm socket
(1) 3/8" Ratchet
(1) 12" or > Torque Bar
(1) 17mm Open End Wrench
(1) 19mm socket

(2) Jack stands
(1) Jack

Alright, first things first, jack up the car on the two front pinch welds, and lower the car safely back down on your two jack stands. Make sure you have the e-brake on to keep the rear wheels from moving. I also suggest chocking the rear wheels.

Below you see the car jacked up and let down on jack stands.



Now, here is a picture of where we will be working under the front end of the car.



Now, there are four bolts we are going to take off in order to bolt on the ladder bar. Please use the picture below for reference of before and after to locate the 17mm bolts I'm talking about.





Now the two forward-most bolts are pretty easy, they aren't torqued too hard, and are just bushing bolts holding the tierod bushings to the engine cradle. Unscrew these shorter sized bolts, and put them to the side. GTSPEC provides you with (2) Bolts and washers to replace these.

Below, you can see the forward-most bolts removed, and compared next to the GT-SPEC Black bolts and washers that come with the bar. The Black bolts have more thread that is needed to bolt the ladder bar up due to the thickness of the ladder bar. Do not re use the two silver OEM front bolts.



Now, the rearward bolts take a little bit more thought, but not much. These longer bolts screw unto the lower camber arm mount point, and go through a shim block and are held in with a nut on the opposite end. This means, to loosen this bolt, you have to hold the other side with an open end wrench. THere is plenty of space to do this, and should not be much trouble.

Below, you will see me loosening the rearward most two longer bolts. Note the open end 17mm wrench above the bolt holding the nut from moving. Let the wrench push against the catalytic converter, you don't need to hold it as you loosen the bolt.



Now that you have your bolts removed, put the ladder bar up against your engine cradle, and bolt it down. NOTE: When replacing the forward-most bolts, use the supplied black bolts WITH WASHERS. Snug up all the bolts with your torque bar, giving it a little elbow grease, and you should be good to go. Let the car back down, and enjoy your sweet ladder bar. NOTE: SHould you get your oil changesd at a lube shop, the grease monkeys under your car will say something, lol.

Below, here is some eye candy that the lube shop monkeys will get to see.



Here's my picture album
__________________
Check out my Albums
'13 Subaru WRX STi | '06 Porsche 911 Carrera S (SOLD) | '96 Mazda RX-7 6.0L V8 RHD (SOLD) | '09 Nissan Nismo #0058 (SOLD)
Equinox is offline   Reply With Quote