Quote:
Originally Posted by wstar
Could be a damaged wire run to one of those sensors, too. Could check that with a meter on the connectors and the wiring diagrams for the sensors in the EC section of the manual. But yeah, if that doesn't work, just cut more wires till the car stops bitching  |
It's possible, but those harnesses ride inside the one that runs down the side of the tranny, so I don't have any reason to think they'd be damaged like the main O2 sensor (drivers side) was from the heat.
Still kicking myself for letting that happen, but I repaired the harness... I just hope it didn't do something to that sensor that's making it blow the fuses.
As a diagnostic step I'm going to disconnect the secondary sensors and do a drive cycle, see if it pops the fuse. If it does not, I will do a few more cycles until I am satisfied and then figure out where to get some O2 bung plugs.
If that does not make any difference, I'll have to sit down with my multimeter and the main sensors and see if I can find a high impedance conductor or something. Sigh.