Quote:
Originally Posted by 1slow370
you will need a couple shims for the side to side unless you get lucky, but you shouldn't have to move the pinion so you can leave the crush spacer and seals and front bearings and shims alone. You will also want to replace the ring gear carrier bearings any time you change the center section out. so you need the ring gear carrier bearings, and maybe shims any time you install a new lsd into a pumpkin.
|
Hi,
Thanks for your reply. I also seen some mention about an install kit for the gears, may I know where I can find this kit?
So to summarize, if I want to go 4:08 on my 7AT + Quaife I will need:
1) Ring Gear Bearing (Could you kindly advise part numbers?)
2) 4:08 Gears From Z1Motorsports
3) Install Kit (Kindly advise where I can get this kit from)
4) Pumpkin (Can I use my existing stock pumpkin??)
5) Shims
Is that all?
Thanks!