Nissan 370Z Forum - View Single Post - Review of Mishimoto Thermostatic Oil Sandwich Plate

1slow370 · 09-11-2013, 03:08 AM

soo.. did you take pics of the plate? cuz there is no o-ring boss hole in the world that seals properly without both the underside of the fitting and the top of the hole being machined with seal surfaces. if it is not counter sunk or counter bored at the plate you need to use a dowty seal. and if its countersunk you cannot just break the thread it must be deep enough to provide a clean 360 degree seal.

Edit: the one in the video is counter-bored correctly so so long as yours looks like that than it had to be an assembly error(unless the counter bore is the wrong size). In the video at 0:45 that is what your' plate needs to have on that hole. I had one of the first original defective GTM kit's that had issues with the lines and my motor popped. I shut it off right away, removed the plate refilled it and drove it while i was getting replacement lines and my motor started throwing timing codes a month later because little pieces of the thrust bearing where plugging the oil passages to the cam actuators. You may not know your motor has had it's life shortened right away. (as a side note you saw how effective that factory oil pressure light is didn't you lol useless)

09-11-2013, 03:08 AM	#41 (permalink)
1slow370 A True Z Fanatic Join Date: Aug 2009 Location: In the D Posts: 3,732 Drives: v8 74 260z ;) Rep Power: 7251	soo.. did you take pics of the plate? cuz there is no o-ring boss hole in the world that seals properly without both the underside of the fitting and the top of the hole being machined with seal surfaces. if it is not counter sunk or counter bored at the plate you need to use a dowty seal. and if its countersunk you cannot just break the thread it must be deep enough to provide a clean 360 degree seal. Edit: the one in the video is counter-bored correctly so so long as yours looks like that than it had to be an assembly error(unless the counter bore is the wrong size). In the video at 0:45 that is what your' plate needs to have on that hole. I had one of the first original defective GTM kit's that had issues with the lines and my motor popped. I shut it off right away, removed the plate refilled it and drove it while i was getting replacement lines and my motor started throwing timing codes a month later because little pieces of the thrust bearing where plugging the oil passages to the cam actuators. You may not know your motor has had it's life shortened right away. (as a side note you saw how effective that factory oil pressure light is didn't you lol useless) __________________ ANSWER PRICE LIST Answers - - - - - - - - - - - - - - - - $0.75 Answers (requiring thought) - - - - $1.25 Answers (correct) - - - - - - - - - - $12.50 Last edited by 1slow370; 09-11-2013 at 03:27 AM.