Could you not get off the other 4 bolts? You didn't round off the nut on any of them did you?
here's what i did:
jack up car. spray bolts with PB Blaster. drive car around to heat up exhaust again. jack up car. spray bolt before using a 6 point deep impact socket and breaker bar. tighten bolt first to get it moving. go the other way and losen/remove bolt.
for the two bolts that had to be removed through the engine bay I used a breaker bar and only impact extensions, most of them were swivel extensions. didn't have to remove the Z1 post MAF tubes. for these bolts i placed the impact socket on the bolt first and from under the car and then had someone feed me the extensions so i knew it was flush and wouldn't strip and pressed into the breaker bar with one hand so it stayed flush as i was turning the breaker bar.
used so much force on the top two bolts that i fell once they loosened and wasn't sure what happened at first.
__________________
Quaife w/ gears |Stillen Gen 3|SOLD FI Resonated Test Pipes |SOLD FI 18'' | 25row Stillen Race | Progress 35mm/25mm sways | Swifts/Koni|Volk G25's| Stoptech SS lines||SPL Front/Rear Arms|
|