Quote:
Originally Posted by gurneyeagle
Hi Rusty
It looks like you ended cutting the tubes on both ducts. On the right side, did you simply angle it down or down and to the grille side?
Thanks!
Mike
|
The right side duct was a pita to get it angled right. It was trial and fit. I ended up cutting the duct on an angle that would allow for clearance with the reducer and hose to pass the washer bottle. Took me about 3hrs to figure it out. So take your time and look on how you want to run the hose. you may end up cutting the duct and the reducer a couple of times to get it to fit.
On the left duct. I cut it to match the right duct. Just so they look the same.
Oh, I used a 2 part epoxy for plastic to glue everything together.