Originally Posted by kenchan

glue pull will never get the amount of force needed to bend that part of decorative lines in the metal. if it did, the paint would crack off (seriously).

glue pull is good for non-aluminum hoods, roofs, trunk lids, some side panels where there is no access from behind. i use glue pullers as last resort as it is very time consuming unless i have to do hail damage.

removing the rear bumper will not gain access to that area. you might be able to access if you took the trunk liner out, but the tech probably can't monitor the metal while he's pushing it out so it would only work to see where a tool can be fed behind the metal while the tech access it from the wheelwell.

this is why im saying he needs to drill the wheel well to gain access if there is no direct access from inside the wheel arch.

definitely dont make the dent bigger. that's a single impact dent, right? making it bigger will just make it that much harder to bend it back especially on decorative lines.

also check your area (or your dealer) for mobile touchup places. the good ones can match your paint very well. spot bondo, sand, and paint. these folks fix used cars that can't be repaired efficiently by PDR.