Quote:
Originally Posted by JAYNO20
After install it looks pretty good, but it is a touch lower on the drivers side.. I know the instructions say to put washers on whichever side you want to bring down a bit, but the tips look aligned fine... its only the canister in the back that looks off... What can I do to line them up without throwing the tips out of wack?
|
JAYNO20,
The height of the mufflers can be adjusted very easily. First and foremost prior to tightening the mufflers down, the back of the X Pipe needs to be level to the earth as stated in the installation instructions.
The hardware we use for the 3 bolt flange is 3/8" as the hole in the flange is 7/16". This gives you some adjustability both clockwise and counterclockwise. What we do is tighten the right side down first with the rotation so the tip is centered in the cutout. From there we put a level on the front bottom of both mufflers to ensure they are level. We then proceed and tighten the left side. 9 out of 10 times the tips line up perfectly in the cutouts. From there if you need to adjust the tip height, do so accordingly with the washers under the hanger.
If you have any questions on any of this or if what I wrote sounds confusing, call me. I will also pm this to you.
Thanks, Tony