Quote:
Originally Posted by b1adesofcha0s
Yeah I put steel wool in on Friday, but didn't work. I already ordered the scanner and should have it by the end of this week or early next week. The code it was throwing is PA200.
|
If you mean P2A00 then try the relearn process:
Here are the instructions:
1. Start engine and warm it up to normal operating temperature.
2. Turn ignition switch OFF.
3. Disconnect mass air flow sensor harness connectors, and restart and run engine for at least 5 seconds at idle speed.
4. Stop engine and reconnect mass air flow sensor harness connector.
5. Make sure DTC P0102 is displayed.
6. Erase the DTC memory.
7. Make sure DTC P0000 is displayed.
8. Run engine for at least 10 minutes at idle speed.