View Single Post
Old 06-10-2013, 04:32 PM   #298 (permalink)
Nut_N_Much
A True Z Fanatic
 
Nut_N_Much's Avatar
 
Join Date: Dec 2011
Location: Pensacola Florida
Posts: 1,696
Drives: Awesome Car
Rep Power: 27
Nut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond reputeNut_N_Much has a reputation beyond repute
Default

Quote:
1) What is the part # of the 350Z 2.5" lipped alum idler pulley set?
2) Are both of your 32T pulleys the 2A033-032?
3) Is your 34T JS pulley still the 4GR032-034?
4) Is the belt for the 34/30 combo still the 2A042-070 (70T, 350Z rev-up)?
5) What did you use to adjust the alignment on the Cog/Idler pulleys? 928 Motorsports - Porsche® 928 Performance Parts - Powerdyne and Vortech® Pulley Spacers - Porsche® 928 World record Holder 216.63537 mph

Thank you in advance.
Sorry for the delay, I was out of town and I wanted to verify the part numbers before posting them for you. Don't want you to have to go back and forth for stuff.

1) Idler Pulley Set: 4GR116-300 $38.95

2) Jack Shaft:
a. 32tooth/4GR032-032 $94.00
b. 34tooth/4GR032-034 $94.00
COG's: 32tooth/35mm wide/ 24033-032 $94.00 *** Recommended, 35mm wide is not made in any other tooth size. They have a 30 tooth COG in a 50mm width. Which works if you build a support strut to keep the SC Plat from flexing under load.

4) Yes thats the size for 30/50mm SC COG & 34/20mm Jack Shaft COG. Also will work with 32/35mm SC COG & 32/20mm Jack Shaft COG: Belt is a Gates 20mm 70 tooth/ 2A042-070 $34.95

5) a. Idler Pulley (Smooth Aluminum w/Flang) is 4GR116-300 $38.95
b. When you buy the impeller get a set of shims. I didn't need any with mine but every SC is different. You might need to shim it to get the right clearances in the compressor. 928 Motorsports - Porsche® 928 Performance Parts - Set of 4 Impeller Shims for*Powerdyne, Vortech®, Paxton Superchargers - Porsche® 928 World record Holder 216.63537 mph
c. Pulley Spacers for the COG's not needed. What is needed is longer grade 8 bolt for the SC side, take the rib SC pulley off and take that bolt to Home Depot and match the threads. You will see what I mean when you take off the rib pulley from the SC the COG is wider depending on which one you use the 50mm is much wider than the 35mm. Will need a longer bolt.
d. Order a set of KEYS when you get your COGs. The keys keep the COGs from spinning on the shaft.

Vortech Superchargers


Nut_N_Much is offline   Reply With Quote