im going to be installing it myself on saturday. all of it. with proper attention to detail, slow procedural steps. doing each step to the best of your abilities, i without a shadow of a doubt believe that anyone.... ANYONE can install a clear bra and have it turn out fantastic. clean the car properly, learn WTF to do before hand with lots of research and vids, use the proper materials and take your damn time. it takes a squirt bottle with 30% "70-91%" isopropylene alcohol 70% water. and another with 100% water and 4-5 dime drops of johnson/johnson baby wash.
it is applied EXACTLY like window tint. clean the **** out of the area. drench the area AND the bra with the baby bottle, and put it on the car. the soap makes it slide around easy with just the lightest touch. then you line it up where you want and start to apply enough pressure to push water under the film but not enough to stretch the material. and do this in small section, 4-6 inches, them peal it back lightly and spray the alcohol mix between the bra and car and squigee it again the same way. all the alcohol does is eliminate the soap so the bra will stick to the car. make sure its lined up BEFORE you spray the alcohol on it or its a ******* nightmare to get it off, involves heat. other than that, its honestly very straight fwd and easy. a little solution under the bra wont matter "TINY AMOUNTS" but air does.
if you cant do this then OMFG dont try to change your oil, this is about that hard "sarcasm implied"
|