Quote:
Originally Posted by Sh0velMan
The Stillen install instructions tell you to torque to 33 Ft/Lbs and then make a mark on the pulley and bolt and then turn the bolt again until the marks are 90 degrees off... Which I found to be totally impossible. I used the break (sans the bumper support lmao) to turn it as far as I could and only got it about 2/3rds of the way to 90 degrees.
Wstar, were you able to?
|
Yeah. I used anti-seize on it as well. If you didn't, that could've made a difference. Either way, I doubt 60 degrees is going to cause you problems.