Nissan 370Z Forum - View Single Post - DIY: Kenwood DNX6140 installed in my 370Z with Sirius and back up Cam (AK370Z)

kenchan · 10-05-2009, 10:52 AM

big- one more q... im getting the rear camera this week and was
wondering how you ran your camera wire into the rear bumper's
license plate area.

the pict below shows where im running the rear foglamp wires
and also where i grabbed the orange reverse wire for the HU.
(this is the driver side rear trunk wall)

is that the same grommet you used to run your camra wire
through? i dont think the pioneer camera's wire comes off so
i would need to wire from the license plate area back into the
grommet which is going to be pretty tricky since i would have
to go diagnally and up...

any other good holes to try?

worse case im going to
drill a new hole.

thanks.

10-05-2009, 10:52 AM	#121 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141521	big- one more q... im getting the rear camera this week and was wondering how you ran your camera wire into the rear bumper's license plate area. the pict below shows where im running the rear foglamp wires and also where i grabbed the orange reverse wire for the HU. (this is the driver side rear trunk wall) is that the same grommet you used to run your camra wire through? i dont think the pioneer camera's wire comes off so i would need to wire from the license plate area back into the grommet which is going to be pretty tricky since i would have to go diagnally and up... any other good holes to try? worse case im going to drill a new hole. thanks.