Originally Posted by simota1

DE is definitely correct on this one... i know it sounds dumb but the cap is the most costly part of this project because it would take my guys probably 2-3 hours from start to finish.... if you add that up that right there is about $180 of labor.... with that being said im definitely going to buy the caps premade and just weld them on... i found a site where the caps costs 50 shipped my last headache is the site glass.... i want people to just look at the side and see where the fluid is at and not have to peak in the tank with a flashlight.... i know the old UAM did not have a sight glass nor the fitting for the breather hose they just drilled a hole on the cap.... i am not to partial about just drilling out a hole on the cap because it will spit.... unless you make the cap a 2 piece breather cap so it wont spit....

basically guys i promise to keep the costs at the lowest but also keep in mind for the combo like DE said... the more i gotta do then the more the cost goes up.... with that being said i can easily see these things costing in the 300 range and the 400 range for the combo cans... now dont write those prices in stone please it could be less or a little bit more....

again i stress i will keep the costs as low as i can but labor is expensive and in the end i gotta make money so its worth my while..... only reason why im even going through this headache is my buddy in japan is asking to start making these "im guessing his gonna start selling these" and he has been a tremendous help in my build