Yes and a buddy of mine... I followed the sticky..for the most part.... Used 400 grit sand paper to rough em up a little bit, then just two good coats of caliper blue, didn't want them to get too dark..waited about 2 hours... Then put the stickers on and two coats of clear engine enamel...have them pre-curing under a spot light for a few hours then will stick them in the oven for a bit...
Not bad for under 50$... Have to see how they hold up... If I had F-ed it up too bad... They were going to get sent to get powdercoated, but I definitely wanted to try and do them myself... I am also going to try and install them...