View Single Post
Old 09-26-2009, 10:47 PM   #67 (permalink)
westpak
Enthusiast Member
 
westpak's Avatar
 
Join Date: Mar 2009
Location: Lake Worth, FL
Posts: 405
Drives: 2003 350Z DB
Rep Power: 16
westpak is on a distinguished road
Default

Quote:
Originally Posted by Valentino View Post
Good job Horsepower Logic.

Questions:

How is the rubber elbow holding @ 7.5psi(the one on the top left of the inter cooler)?

Would that rubber hoes take the heat and abuse of higher boost in the long run with out coming off or get damaged?

Thanks
well tough to tell since so far it has only been a few pulls on the dyno, but it held up fine with no obvious bulging, if that is your concern, it is pretty thick and as for heat, it wont see any more heat than the rest of the plastic/rubber parts in the engine bay.

it is similar if not the same as the parts used in the Injen cold air intakes.
westpak is offline   Reply With Quote