Quote:
Originally Posted by bigaudiofanat
If you tap into the speaker level outputs of the bose amp, you will only get highs or lows depending on which set you tap into. The reason is the bose amp splits the signal before going out to the speakers.
So instead of trying to sum multiple signals, tap into the low level signal going into the bose amp. This will give you a full signal with everything from highs to lows.
|
Thanks Matt....as usual
So basically I can disconnect the wires from the bass output of the Bose that I tapped that I have going to the LOC (for sub amp) and replace them on the LOC with the low levels that would be going into the Bose and this will be good for both amps (high & lows)? Then I can completely remove the Bose amp? I wasn't sure if the frequency limiting was at the HU or the Bose amp.
.
.