View Single Post
Old 01-21-2013, 01:13 PM   #26 (permalink)
roy'sz
A True Z Fanatic
 
roy'sz's Avatar
 
Join Date: Aug 2011
Location: palmdale, ca
Posts: 1,299
Drives: 2010 nissan 370z
Rep Power: 16
roy'sz will become famous soon enough
Default

you could drill a hole in the top of the intake and use a expoxy to seal up the whole if you use a thermocouple. Which brings the question of where is the intake air temp being read at? I thought it was the maf but I may be wrong. I don't disagree when it comes to pulling air outside, but here is my stumbling block. We as a customer are spending 150bucks on 3 degrees of air for 3 or 4 hp (gen3, aem, injen, etc) compared to a k&n or takeda? Most of the times cruising down the hwy the difference would be an avg of 5 or 6* right? if you are stuck in traffic then they both seem to have the same heat soak.

Also some useful information, the other night I took the wife out on date night in the z. When we left the resturante from dinner my intake air temp was around 130 from being parked for dinner. After some city driving (ambient temp was 44) it dropped down to about 95. When I got on the hwy it plummeted in a matter of 20-45 seconds to 46.
__________________
https://www.youtube.com/watch?v=RtvG...data_playerARK HFC'S-ARK Grip-Stillen G3-M370-UPREV-Kinetix upper control arm-WC Latheworks-Stage2 Bad@$$ Driver(318whp/268tq)-
roy'sz is offline   Reply With Quote