Quote:
Originally Posted by BlkNismo
Available configuration for oem nismo exhaust?
|
Not confirmed at this time. If it can bolt up to the regular OEM Y-pipe, then yes it would work just fine.
Quote:
Originally Posted by ENT-Z
Did you get any further ideas about saving the crash bar during this install?
|
I did have a look at it, and I don't have the proper materials on hand to make it work. In order to make it work I would have to use very long leg 90deg silicone couplers. These are neede (at the FMIC outlets) in order to get far enough in to the engine bay so that one can get at the T-bolt clamps needed to clamp the charge pipes going to the TB's.
The way it is set up now, the clamps on the regular silicone 90's can be clamped wit the bumpe off, then the hard pipes go through the the front rad support. Hope that makes sense.