ZedHead here is some ammo for you to use with your dealership too while I'm answering Cvzg77r's question as well.
Per the 2009 370Z Factory Service Manual: Clutch Section - Page 16
"Removal and Installation INFOID:0000000004554597
CAUTION:• Never reuse CSC (Concentric Slave Cylinder) body and CSC tube. Because CSC slides back to the original position every time when removing transmission assembly. At this timing, dust on the sliding parts may damage a seal of CSC and may cause clutch fluid leakage.
• Never disassemble CSC body.
• Keep painted surface on the body or other parts free of clutch fluid. If it spills, wipe up immediately and wash the affected area with water.
REMOVAL
1. Remove transmission assembly from the engine. Refer to TM-31, "WITHOUT S-MODE : Removal and Installation" (Without S-MODE) or TM-34, "WITH S-MODE : Removal and Installation" (With S-MODE). "
Hope it helps.
Last edited by Ryan @ RJM; 09-04-2012 at 07:30 PM.
|