LOL hey! I had just commented about this. I have seen this before. It looks like to me the lip causes a good amount of downforce over the nose of the car and its warping the urethane lip over time or the 3M tape is not capable of holding up to the stress levels. I would say the lip cannot be installed with just simple 3M tape and a few screws. I have twelve screws and nuts installed in mine with about 4 inch seperation between all screws and bolts.
Stillen's installation instructions are simple on paper but in order to really install the lip correctly and provide the lip with additional structural regidity, you MUST remove the front bumper and intall the lips with actual screws and nuts inside the bumper.
However, I believe Stillen offers a lifetime warranty for this part. Have you spoken to Stillen yet about his issue?
|