Just finished the 20mm on the rear. I didn't need to take the parking break assembly off either. I just angled the studs and slowly turned the hub until I could just slide the stud in place. Hopefully I seated them well enough. I'm pretty sure I got them all flush but I sometimes don't trust myself.
I noticed that the driver side was really dirty/greasy and the passenger side was not. Anyone know if I should be worried about the bearings or something of that nature??
I'll have to finish the 15mm front after work tomorrow. I will be sporting the fat rear end on the road tomorrow
-
Wheee, thanks for the write up. It was a huge help.... also gave me a reason to buy an impact wrench, I would have been cussing myself had I not.