fritz

Hi,

Euphoria pervades this thread!

I (equally self-congratulatory) think "for real" is misleading and was already done by me. It's better done well away from electrical HQ which takes a lot of time to get at with care...and is slightly risky.

Hence my original thread starter "Steering lock cut the wire/switch optional"

Do not regret the harness ... a fifty very well spent. (not on me!)

The harness or cut the wire: either seems the best solution by far. rhd has an excellent photoset on the thread "Cutting the brownie".

Either way is lightning fast and involves no removal of plastics and IPDM. Add a switch and you have complete flexibility (especially for testing engine problems, and also have security better than Nissan's OE)

[Pressing the brake pedal on an M/6 in neutral, OKs an engine start-up too]

The fuse is a little obvious.
I would not suggest a DIY-er go anywhere near the IPDM area or its fuses.
Lifting it out spells problems for amateurs. Wiring disconnects or shorts, or simple fatigue without great gentle care, (all the wiring is so short) can cost a fortune as in locating the problem(s) and passing blame.

"fuse" sounds great but they are not at all easy to get at amidst a maze of wiring and relays. The IPDM is "not serviceable" (fuses apart) is expensive, and your dealer may ask embarassing questions about a missing fuse at this heart of your electrical systems.....and blame you for everything anywhere.

Further you can not change a switched mode without much work and Interference with the IPDM, but can change everything in minutes with a cut wire, especially on a harness.

Whatever works, works.

Fritz