Nissan 370Z Forum - View Single Post

Volk Z · 03-14-2012, 02:58 PM

I think as long as you stay under a 23 inch shoulder portion on seats you should be fine. If memory serves me well on the above seats those are under 23 inches for the top shoulder width.

It will slightly depend on the bracket you use as well... If you can use a side mount bracket you can slightly adjust how the seat sits where as an undermount bracket is a fixed position/spot the seat will sit in.

I ran a Corbeau FX1 Pro 23 inches across for shoulder and it rubbed the door slightly with the corbeau bracket but with the side mount Buddy club brackets it was a 1/4 inch away from the door and could have gotten a little more wiggle room if needed.

Example seats that should be ok off the top of my head- All under or at 23 inch shoulder across
Status Ring
Sparco EVO (regular not 2, 3 etc)
Corbeau FX1 Pro or Regular FX1
Bride Vios III
Bride Zieg III
Bride Artis III

03-14-2012, 02:58 PM	#2 (permalink)
Volk Z A True Z Fanatic Join Date: Aug 2011 Location: Laguna Beach, CA Posts: 2,214 Drives: Nismo Z Rep Power: 3066	I think as long as you stay under a 23 inch shoulder portion on seats you should be fine. If memory serves me well on the above seats those are under 23 inches for the top shoulder width. It will slightly depend on the bracket you use as well... If you can use a side mount bracket you can slightly adjust how the seat sits where as an undermount bracket is a fixed position/spot the seat will sit in. I ran a Corbeau FX1 Pro 23 inches across for shoulder and it rubbed the door slightly with the corbeau bracket but with the side mount Buddy club brackets it was a 1/4 inch away from the door and could have gotten a little more wiggle room if needed. Example seats that should be ok off the top of my head- All under or at 23 inch shoulder across Status Ring Sparco EVO (regular not 2, 3 etc) Corbeau FX1 Pro or Regular FX1 Bride Vios III Bride Zieg III Bride Artis III __________________ AMUSE * TOMEI * STILLEN * CRAFTSQUARE RECARO * 3M * TOP SECRET * SLICKCARBON Last edited by Volk Z; 03-14-2012 at 03:01 PM.