Don't know if this is useful to other people but I was looking around at braided stainless steel AN type hosing to replace some of the rubber hosing. I had no idea what what all the sizes were so found this nifty little chart that converts inches to -AN. Basically, an AN style size is the measurement of the Inner Diameter of the hose measured in units of 1/16th of an inch. So...
an -2 hose has an I.D. of 1/8"
an -3 hose has an I.D. of 3/16"
an -4 hose has an I.D. of 1/4"
an -5 hose has an I.D. of 5/16"
an -6 hose has an I.D. of 3/8"
an -8 hose has an I.D. of 1/2"
an -10 hose has an I.D. of 5/8"
an -12 hose has an I.D. of 3/4"
an -16 hose has an I.D. of 1"
an -20 hose has an I.D. of 1 1/4"
...this ain't high on my priority list, but I do plan on doing all the PCV stuff when I get my Saiku Maichi OCC set up ... then do some others on down the road.
__________________
 || Build Journal || Follow Us: Web Site || Facebook ||
Quote:
|
"I got lapped by the pace car at Summit Point. Not many can say that." -- sixpax
|
Last edited by sixpax; 02-11-2012 at 03:53 PM.
|