View Single Post
Old 02-06-2012, 09:15 AM   #48 (permalink)
wstar
A True Z Fanatic
 
wstar's Avatar
 
Join Date: Mar 2009
Location: Houston, TX
Posts: 4,024
Drives: too slow
Rep Power: 3594
wstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond reputewstar has a reputation beyond repute
Default

My primary issue with using jacks on this car is that many of the "low profile" jacks can't reach deep enough under the car to hit the jack points I want to use. They're only low-profile at the front of the jack, as if you'd only ever use it on the edge of the car.

My solution was to buy one of these adapters: Amazon.com: Floor Jack Saddle Adapter for Rocker Panel Pinch Weld: Automotive. The adapter is meant to allow a normal floor jack to use the edge jack points on the car (the ones that have a metal seam sticking down, that the stupid little screw jack in the trunk is design to operate around by having a slit in it).

Then I searched around several hardware/auto stores in the area opening low-ish profile jack boxes until I found some random crappy model that actually had a removable jacking surface that left behind a circular hole the adapter could fit in. The combination works pretty well; I now have a floor jack I can use on the 4x factory jack points at the very side edges of the car to lift a corner and get a jack-stand underneath.
__________________
7AT Track Car!
Journal thread / Car setup details
wstar is offline   Reply With Quote