Quote:
Originally Posted by kannibul
That was common sense 30 years ago, when tolerances were measured in fractions of an inch, not fractions of a millimeter!  |
Right because fractions of an inch are smaller/different than fractions of a milimeter? So a tolerance of 1/10th of a mm is better than 1/10000 of an inch? I know what you are trying to say but it didn't quite come out right....
Does it seriously hurt to check your oil frequently? You do realize this is a mechanical device that can from time to time fail. If you observe normal and not normal behaviour you can prevent sometimes catastrophic failure. A little time invested is worth the grief it can prevent you.