Nissan 370Z Forum - View Single Post

bushman66 · 01-15-2012, 01:33 PM

Has anyone tried to use the factory visor clip to hook the Valentine 1 to the headliner? Basically, I did this on my Mini Cooper S, by reversing the clip and sliding it over the edge of the headliner at the windshield. This placed the V1 high enough that it was invisible from the exterior of the car.

The 370Z has a vertical "lip" on the headliner though. Was just wondering if anyone had attempted to cut or slit this lip to allow the mount to slide in this way? Is the headliner sturdy enough to hold the V1 without sagging?

Looked at the Blendmount and it just sits too low and is too visible from the outside. Don't want to draw any attention from the "smash and grab" crowd!

01-15-2012, 01:33 PM	#1 (permalink)
bushman66 Base Member Join Date: May 2010 Location: AZ Posts: 112 Drives: 2012 370Z Red Sp Pkg Rep Power: 15	Valentine 1 mount into headliner Has anyone tried to use the factory visor clip to hook the Valentine 1 to the headliner? Basically, I did this on my Mini Cooper S, by reversing the clip and sliding it over the edge of the headliner at the windshield. This placed the V1 high enough that it was invisible from the exterior of the car. The 370Z has a vertical "lip" on the headliner though. Was just wondering if anyone had attempted to cut or slit this lip to allow the mount to slide in this way? Is the headliner sturdy enough to hold the V1 without sagging? Looked at the Blendmount and it just sits too low and is too visible from the outside. Don't want to draw any attention from the "smash and grab" crowd!