thanks everyone.
1) for the booster control; i had to open the unit up and then trim back about a 1/2" of the black wire covering. this is so the wires can fit inside the 370z switch blank (the blank will have to be smoothed out on the inside also).
2) after i had the booster switch all apart; i had to trim both ends about 1/16 to a 1/4". this is so the booster switch can fit inside the 370z switch blank.
3) then i test fit everything. this allowed me to pick up the hole to drill thru the 370z blank , for the clear led button.
4) after that i took it all back apart and filed down the thickness of the booster top piece where the clear led button goes thru. this allows the clear button to stick thru the 370z switch black better.
5) clean all the dust out and wipe clean with acetone. then crazy glue in the top of the booster switch cover, to the inside of the 370z switch blank (careful to line up the hole you drilled). let dry completely.
6) now instal clear button, circuit board and back plate. check for proper button operation with your finger holding the back plate in place.
7) use a small amount of crazy glue to glue the sides of the back plate on. let dry.
8) now fill the rest of the inside of the 370z switch blank with hot glue. let dry / cool, and your done!
|