Quote:
Originally Posted by Srenity
No Z action today. But yesterday I wrapped up the Swift Springs, ichiba camber arms and wheel spacer (15mm & 20mm) that I started this weekend. The job is definetly a pain in the butt without an air impact. Looks pretty good and I like the ride of the Swifts on the short test drive I did. Will get some pics up soon. There is some problem with a low speed only suspension noise that I have not been able to identify. I will do a little searching on here and start a post in the suspension section if I do not find an answer.
|
Quote:
Originally Posted by happytheman
You may need to twist the spring, as it may not be seated properly.
|
Quote:
Originally Posted by Footloose301
Tighten the nut on the top hat now that the weight of the car is compressing the springs. Hold the strut with vice grips and use an open ended wrench to tighten the nut. I had similar issues because mine wasn't tight when I installed the spring over the strut. I thought it was tight at the time.
|
Quote:
Originally Posted by Srenity
Right now I am thinking that it may be the front sway bar endlink. The noise is only at low speeds and seems constant with some issues I read on other treads. I will check that out when I get some time. Any other potential low speed only clunk causers?
|
Did you install the plastic piece from your OEM springs? It sits on the top of the coil spring. Lube up the end links and strut bar rubber cushions. Just a thought
Quote:
Originally Posted by kenchan
my buddy in LA mentioned 42F or something today in socaland? that's pretty cold for you guys.  was 28F on the way home today for me. kinda chilly.
.  |
35F this morning in NorCal.... a bit nippy