I don't have tools for getting the car up and bumper removal is a b*** so I am looking for a method where I can just do it once for the initial blocker plate install and be able to place/remove the plate afterwards without removing the bumper. Anyone have any ideas for this? I think the whole Z community would be very interested. I was thinking of only blocking off 2/3 or about 15/16 rows of the oil cooler also. My temps int he cold air (for southern california) range form 160 - 205 depending on traffic so I figure blocking 2/3 of the cooler would put me into the 190ish range for my low end and still keep me form getting too hot if it's bad traffic during warmer daytime hours.
__________________
Works Emotion CR Ultimate - FI CBE w/ 18" resonators - Ecutek - eibach sways - Quaife - FI LTH w/race cats - kw v3 - spl - Topgunz SC - 488whp 398trq
|