Quote:
Originally Posted by DIGItonium
PLCC2 works, but you have to mask off one of the pads or it'll short to ground. If you look at the photos, I used yellow masking tape to mask off one of the pads. Then I was able to place the LED over the same spot and solder both sides (leaving the masked pad isolated from solder).
|
so you put masking tape over 4 solder pads? and just soldered the LEDS ? even the 4 solder pads with the tape underneath the LED? and i have a problem..my screen where the fuel and all that is is now half blank...i think i ruined something.. =(