Thread: about ATF
View Single Post
Old 10-06-2011, 07:06 AM   #16 (permalink)
ImportConvert
A True Z Fanatic
 
ImportConvert's Avatar
 
Join Date: Jun 2010
Location: SWMO
Posts: 4,454
Drives: 2019 CX5 GT Reserve
Rep Power: 7627
ImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond reputeImportConvert has a reputation beyond repute
Default

Quote:
Originally Posted by bvl View Post
The WS6 is a manually: different fluid properties. Many trannies tend to like a particular additive package a tad more if you are that sensitive to shift feel (you trade off smoothness for bearing wear over a long time. Few good docs on this, including Redline as they make several different packages for manuals and diffs)

As you note: dirty does not mean bad. Unless you run an analysis on the used stuff, you don't know the additive package and fluid composition. Regular motor oil will darken in 1-2K (if not less) miles but is working just peachy.

100K maintenance free is really a demand of consumers: they feel its a hassle to maintain a car (face it: most americans can't check air pressure, its sad but true).

That said, most manufacturers have 'premium' style service intervals which do still replace fluids more aggressively. Varies by car of course. Diff, transfer, MT, AT, and brake fluid are just a few that often go un-maintained.

- b
Lets put it this way, the WS6 did fine until I swapped trans fluid. Then it was a bit harder to shift in the cold it seemed. Fluid was OEM spec from Prestone.

The rear-end was fine until I changed that, too. Went with Royal Purple 85-140 synthetic, as it had a mechanical worm-gear type posi. After destroying the pinion-bearing and a set of axles within a few thousand miles...screw Royal Purple.

Point is, the car was fine until I started "maintaining" the fluids.

I should have learned my lesson on my '95 Trans Am, which was a PITA to get right again after doing the diff fluid in that. IT had an auburn style posi and we monkeyed with mixing the right amount of anti-slip addative for quite some time before it would again go around corners without shuddering.


Then I tried the same thing on my G20 because "It's an import".
Fail.

JUST LEAVE IT THE HELL ALONE!

That's the best advice I've got. It was told to me my whole life, I defied it and ended up with a blown rear-end on my WS6 and a dead transmission in my G20. I learned my lesson!

Manufacturers don't say "Maintenance free" out of convenience. If that were the case, timing-gear belts would also be "maintenance free". Well, they aren't. They cost a lot more to replace than transmission fluid, but if you don't do it, well, I have seen plenty of mangled heads because of that. I have never ONCE! seen a transmission or rear-end that died because the fluid was not changed. They have died because of being operated in an over-heated condition, but never once did we have one come into the dealership dead due to "dirty fluid". In fact, there was only only car that came in for fluid related issues regarding "lack of maintenance" while I was at that Ford dealership (A period of 1 year). A retro style T-bird with a siezed engine and IIRC 28K miles on the odometer. OEM oil/filter. Even then, it seized because of LACK of oil in the sump/engine, not "dirty oil".

Last edited by ImportConvert; 10-06-2011 at 07:11 AM.
ImportConvert is offline   Reply With Quote