|
A True Z Fanatic
Join Date: Nov 2010
Location: Fields of Opportunities
Posts: 1,406
Drives: '12 5.0, kona, 6MT
Rep Power: 18
|
Quote:
Originally Posted by ImportConvert
Sounds like you did it right.
FWIW, the GM tech that took my car onto the rollers at Bowling Green got it up to 4400rpm, and he wasn't a weenie about getting it there, either. Got it up to 83mph, too, from what I recall (in my manual, some BS about 55mph=max for break-in).
You did all you can do to "do it right" it sounds like.
Don't forget though, perhaps even more than the engine, you are breaking in the axles, wheel-bearings, clutch surfaces, brake surfaces, rotor surfaces, flywheel surface, transmission internals, etc. This is all important, too. Whatever you do, do NOT "shock" the drive-line until it is worn in. My Z06's manual says "No HPDE's until 1500+ miles".
Good advice imo.
___________
If you determine that you are using too much oil for your taste, by all means, begin the process with Nissan.
|
I agree with all you said. I "hope" I don't have an OC problem... the master techs I spoke said that the OC problem is very very very rare. Most folks will go through some OC, but goes away... just need to monitor it. I hope I am not the statistical outlier....lol.
__________________
2012 5.0 GT Prem, Kona Blue, 6MT, HID, Brembo, 3.73 -- Ordered: 9/20/11, Born on: 10/20/11, Delivered 11/15/11"Marilyn" GT500 mufflers/flaps, MGW shifter, FRPP K springs, BMR panhard bar, Boss coil covers, 3DC spoiler, Llumar Tint (35% and 20%), 3M ClearBra
|