Quote:
Originally Posted by Mr.Squeeze
I have a 928 2.87 pulley as well as a vortech 3.12, 3.33. This is all left over parts from my 350 vortech kit.It won't fit when I first got the Stillen kit I tried using it. The only pulleys I was able to use were the cog pulleys. The Stillen pulleys are wider this has to do with the belt being wider on the 370 from the 350.
|
Are the pulleys you are referring to run from the main drive belt or the belt that runs around the jackshaft pulley and the SC pulley? I am assuming that you are talking about the pulley that is run off of the main belt. I still need to do a little research before pulling the trigger on a pulley.
I am interested in your cog pulley setup but am not sure if I want to go that route at this point. Had I known about it before my install I might have gone that route but I am not sure if I want to go through the hassle of removing all the stuff necessary to install the cog setup instead of swapping out the front side pulley which is a very simple operation. BTW, what was the total cost of the cog setup if you don't mind me asking?
__________________
2008 G37s 5AT, Stillen SC, Stillen CBE, Stillen tranny cooler, DBA 5000 front/4000 rear, Stillen sways, Tein SS-P coilovers, SPC front & rear control arms, Goodridge lines
|